PCB letter

For this assignment in homemade hardware I was assigned the letter G to mill. This will be my first time ever milling anything so I hope it works.

I have not been able to figure out how to connect the rectangle I drew (nor am I sure this is the correct way to go about it) to the 1 mio. ohm resistor, to make the capacitive sensor for the assignment. I wanted to make it onboard the board.

Programmable letter made form PCB board with embedded ATtiny

The files are available here:

https://github.com/louiselessel/HomemadeHardware_git/tree/master/HomemadeHardware_Letter